G GENERAL
82410·
82710·
82910 WSM,
12271
Replacing Hydraulic Oil Filter Cartridge
A CAUTION
•
Be
sure to stop the engine before changing the oil filters.
1.
Drain the transmission fluid.
2.
Remove the oil filter cartridge by using a filter wrench.
3.
Apply a slight coat
of
oil onto the cartridge gasket.
4.
To install the new cartridge, screw
it
in
by hand. Over tightening
may cause deformation
of
rubber gasket.
5.
After the new cartridge has been replaced, the transmission fluid
level will normally decrease slightly. Make sure that the
transmission fluid does not leak through the seal. Check the
fluid level.
• IMPORTANT
• To prevent serious damage to the hydraulic system. Use
only
a genuine KUBOTA filter or its equivalents.
(1) Hydraulic Oil Filter (for HST)
(2)
Hydraulic Oil Filter
12490G00090
12490F00140
Cleaning Transmission Oil Strainer
1.
Clean the strainer with nonflammable solvent.
• NOTE
• When changing the transmission fluid, disassemble and
rinse the strainer with nonflammable solvent to completely
clean off fillings.
When reassembling, be careful not to damage the parts.
• Since the fine fillings
in
the oil could impair the component
parts of the hydraulic system precision built to withstand
high pressure, the suction line end
is
provided with an oil
strainer.
• Please do the replacing oil filter cartridge (3) and the
cleaning oil strainer (1) at the same time. And when
replacing, reinstall the oil strainer first.
(1)
Strainer
(3)
Hydraulic Oil Filter Cartridge
(2)
a-ring
12271G00070
G-14
To Next Page
Loading...
Need help?
General
