EasyManuals Logo
Home>NETGEAR>Switch>M4100 Series

NETGEAR M4100 Series User Manual

NETGEAR M4100 Series
446 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #167 background imageLoading...
Page #167 background image
Configure Switching Information
167
M4100 Series Managed Switch
8. Use the Interface check boxes to select the interface.
9. In the Admin Mode field, select Enable or Disable.
This specifies interface mode for the selected interface for IGMP snooping for the switch.
The default is Disable.
10. In the Group Membership Interval field, specify the amount of time you want the switch to
wait for a report for a particular group on a particular interface before it deletes that interface
from the group.
Enter a value between 1 and 3600 seconds. The default is 260 seconds.
11. In the Max Response Time field, specify the amount of time the switch waits after sending
a query on an interface because it did not receive a report for a particular group on that
interface.
Enter a value greater than or equal to 1 and less than the group membership interval in
seconds. The default is 10 seconds. The configured value must be less than the group
membership interval.
12. In the Present Expiration Time field, specify the amount of time the switch waits to receive
a query on an interface before removing it from the list of interfaces with multicast routers
attached.
Enter a value between 0 and 3600 seconds. The default is 0 seconds. A value of zero
indicates an infinite time-out, for example no expiration.
13. For Fast Leave Admin mode, select Enable or Disable.
This applies to the particular interface. The default is Disable.
14. Click the APPLY button.
Your settings are applied to the switch. Configuration changes take effect immediately.
Configure IGMP Snooping Settings for VLANs
You can configure IGMP snooping settings for VLANs on the system.
 To configure IGMP snooping settings for VLANs:
1. Prepare your computer with a static IP address in the 169.254.100.0 subnet, for
example, 169.254.100.201.
2. Connect an Ethernet cable from an Ethernet port on your computer to an Ethernet port on
the switch.
3. Launch a web browser.
4. Enter the IP address of the switch in the web browser address field.
The default IP address of the switch is 169.254.100.100.
The Login screen displays.
5. Enter the user name and password.

Table of Contents

Other manuals for NETGEAR M4100 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR M4100 Series and is the answer not in the manual?

NETGEAR M4100 Series Specifications

General IconGeneral
BrandNETGEAR
ModelM4100 Series
CategorySwitch
LanguageEnglish

Related product manuals