NETGEAR M4100 Series User Manual

Manage Device Security
268
M4100 Series Managed Switch
The valid range is 1 – 30. The default value is 5.
Give consideration to maximum delay time when configuring RADIUS maximum
retransmits and RADIUS time-outs. If multiple RADIUS servers are configured, the
maximum retransmit value on each is exhausted before the next server is attempted.
A
retransmit does not occur until the configured time-out value on that server has passed
without a response from the RADIUS server. Therefore, the maximum delay in receiving
a response from the RADIUS application equals the retransmit times time-out for all
configured servers. If the RADIUS request was generated by a user login attempt, all user
interfaces are blocked until the RADIUS application returns a response.
10. Select the
Accounting Mode Disable or Enable radio button.
This specifies whether the RADIUS accounting mode is enabled or disabled on the
current server
.
11. Select the RADIUS attribute 4 Disable or Enable radio button to enable or disable RADIUS
attribute 4.
The default value is Disable. The Radius
Attribute 4 Value is an optional field and can
be seen only when Radius attribute 4 Mode is enabled. It takes an IP address value in the
format (xx.xx.xx.xx).
The following table describes the nonconfigurable information displayed on the screen.
Table 77. RADIUS Configuration
Field Description
Current Server Address The address of the current server. This field is blank if no servers are
configured.
Number of Configured
Authentication Servers
Displays the number of configured authentication RADIUS servers. The
value can range from 0 to 32.
Number of Configured Accounting
Servers
Displays the number of RADIUS accounting servers configured. The
value can range from 0 to 32.
Number of Named Authentication
Server Groups
Displays the number of named RADIUS server authentication groups
configured.
Number of Named Accounting
Server Groups
Displays the number of Named RADIUS server accounting groups
configured.
Configure a RADIUS Server
You can view and configure various settings for the current RADIUS server configured on the
system.
 To configure a RADIUS server:
1. Prepare your computer with a static IP address in the 169.254.100.0 subnet, for
example, 169.254.100.201.

NETGEAR M4100 Series Specifications

General

Brand	NETGEAR
Model	M4100 Series
Category	Switch
Language	English