Configure System Information
59
M4100 Series Managed Switch
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
6. Click the Login button.
The web management interface menu displays.
7. Select System > Services > DHCP Server> DHCP Server Configuration.
8. Select the Admin Mode Disable or Enable radio button.
This specifies whether the DHCP service is enabled or disabled. The default value is
Disable.
9. Use Ping Packet Count to specify the number of packets a server sends to a pool address
to check for duplication as part of a ping operation.
The default value is 2. The valid range is 0, 2 to 10. Setting the value to 0 disables the
function.
10. Select the Conflict Logging Mode Disable or Enable radio button
This specifies whether conflict logging on a DHCP server is enabled. The default value is
Enable.
11. Select the BOOTP
Automatic Mode Disable or Enable radio button
This specifies whether BOOTP for dynamic pools is enabled. The default value is
Disable.
12. Click the APPL
Y button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately
.
Exclude an Address from the DHCP Server
 To exclude an address from the DHCP server:
1. Prepare your computer with a static IP address in the 169.254.100.0 subnet, for
example, 169.254.100.201.
To Next Page
Loading...
Need help?
General