wsm M6060 - Clutch Housing; Creep Gear Assembly; 1 St Shaft, 2 Nd Shaft and 3 Rd Shaft

TRANSMISSION
M6060, M7060, WSM
2-S38
[9] CLUTCH HOUSING
(1) Creep Gear Assembly
Creep Gear
1. Remove the creep gear cover (2) as a unit.
2. Remove the internal circlip (1).
3. Tap out the creep gear shift (4) and remove the creep gear (3).
(When reassembling)
• Apply liquid gasket (Three Bond 1206C or equivalent) to joint
face.
9Y1210828TRS0058US0
(2) 1st Shaft, 2nd Shaft and 3rd Shaft
36T Gear
1. Remove the external circlip (2) and 36T gear (1).
(When reassembling)
• Check the clearance "L" between external circlip (1) and
adjusting collar (3).
• If the measurement is not within the factory specification, adjust
with shim.
(Reference)
• Thickness of adjusting collar (3).
3.00 mm (0.118 in.) [Code No.: 3C001-28410]
3.2 mm (0.126 in.) [Code No.: 3C001-28420]
3.4 mm (0.134 in.) [Code No.: 3C001-28430]
3.6 mm (0.142 in.) [Code No.: 3C001-28441]
9Y1210828TRS0059US0
Tightening torque Creep gear cover
48.1 to 55.8 N·m
4.9 to 5.7 kgf·m
35.5 to 41.2 lbf·ft
(1) Internal Circlip
(2) Creep Gear Cover
(3) Creep Gear
(4) Creep Gear Shaft
Clearance "L" between
external circlip and
adjusting collar
Factory specification
0.2 mm
0.0078 in.
or less
(1) 36T Gear
(2) External Circlip
(3) Adjusting Collar
L: Clearance
KiSC issued 08, 2013 A