GENERAL
M6060, M7060, WSM
G-36
[9] CHECK POINTS OF EVERY 1000 HOURS
Adjusting Engine Valve Clearance
• See page 1-S12.
9Y1210828GEG0040US0
Changing Transmission Fluid
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. To drain the used oil, remove the drain plug (1) at the bottom of
the transmission case and drain the oil completely into the oil
pan.
2. After draining reinstall the drain plug.
3. Fill with the new KUBOTA SUPER UDT fluid up to the upper
notch on the dipstick (2). (Refer to "4. LUBRICANTS, FUEL
AND COOLANT" on page G-13.)
4. After running the engine for a few minutes, stop it and check the
oil level again; add oil to prescribed level.
• Do not operate the tractor immediately after changing the
transmission fluid.
Run the engine at medium speed for a few minutes to
prevent damage to the transmission.
9Y1210828GEG0041US0
Oil capacity
56 L
59.2 U.S.qts.
49.3 Imp.qts.
(1) Drain Plug
(2) Dipstick
(3) Oil Inlet
(A) Oil level is acceptable within the
range.
To Next Page
Loading...
Need help?
General
