wsm M6060 User Manual

BRAKES
M6060, M7060, WSM
4-S12
(3) Removing Master Cylinder (ROPS Model)
Brake Pipes and Master Cylinder Pipes
1. Remove the panel cover.
2. Remove the master cylinder pipe (3) and master cylinder return
pipe (2) from the master cylinder assembly (1).
3. Remove the brake pipe L.H. (5) and R.H. (4).
9Y1210828BRS0014US0
Master Cylinder Rod and Master Cylinder
1. Remove the master cylinder snap pin (1) from brake pedal (2).
2. Remove the master cylinder mounting nuts (3).
3. Remove the master cylinder assembly.
(When reassembling)
• After mounting the master cylinder assembly, be sure to bleed
air. (See page 4-S6.)
9Y1210828BRS0015US0
(4) Removing Master Cylinder (CABIN Model)
Master Cylinder Rod
1. Remove the pedal shaft support (1).
2. Disconnect the 1P connectors (2).
3. Remove the master cylinder snap pins (3) from brake pedals
(4).
9Y1210828BRS0016US0
Tightening torque
Brake pipe retaining nut
16 to 24 N·m
1.6 to 2.5 kgf·m
12 to 18 lbf·ft
Master cylinder pipe and
return pipe retaining nut
49 to 68 N·m
5.0 to 7.0 kgf·m
37 to 50 lbf·ft
(1) Master Cylinder Assembly
(2) Master Cylinder Return Hose
(3) Master Cylinder Pipe
(4) Brake Pipe R.H.
(5) Brake Pipe L.H.
(1) Snap Pin
(2) Brake Pedal
(3) Cylinder Mounting Nut
(1) Pedal Shaft Support
(2) 1P Connector (Brake Switch)
(3) Snap Pin
(4) Brake Pedal
KiSC issued 08, 2013 A

wsm M6060 Specifications

General

Brand	wsm
Model	M6060
Category	Tractor
Language	English