6
D-STAR OPERATION <BASIC>
6-23
“TO”(Destination)setting
To make a Local Area CQ call
“LocalCQ”setting(p.6-13)
Set “CQCQCQ” in “TO” (Destination).
To select from RX History
SettingfromRXHistory(p.6-26)
When you receive a call, the repeater or caller sta-
tion data is stored in RX History.
You can select the destination from the record.
To select from TX History
SettingfromTXHistory(p.6-27)
When you make a call, the destination repeater or
called station data is stored in TX History.
You can select the destination from the record.
To directly enter the destination station call sign
DirectInput(UR)(p.6-28)
Directly enter the destination station’s call sign.
To directly enter the destination repeater call sign
DirectInput(RPT)(p.6-29)
Directly enter the destination repeater’s call sign.
To make a call to a specific station
“YourCallSign”setting(p.6-25)
Select the station call sign in the Your Call Sign
memory.
To make a Gateway CQ call
“GatewayCQ”setting(p.6-14)
Select a repeater from the repeater list, if you want
to make a Gateway call.
Settingbyrotating[DIAL]
Rotate [DIAL] to select the repeater or Your Call
Sign that is displayed on the DR screen. (This op-
eration is disabled when “CQCQCQ” is set.)
The destination repeater or station must be set in “TO”
when you make a call in the DV mode.
You have eight ways to set the destination.
Howtochangetherepeatergroup:
When “Local CQ” or “Gate-
way CQ” is selected, you can
change the repeater group.
While in the DR screen, ➥
touch [QUICK], and then
touch “Group Select.”
[TOSELECT]screen
To make a call through a reflector
“Reector”setting(p.6-31)
Select a reflector you want to call through.
Foryourreference:
After you receive the individual station or repeater’s
signal, the call sign can be captured by holding down
the Call Sign Capture key ([RX>CS]), and you can
quickly and easily reply to a call.
To Next Page
Loading...
Need help?
General
