Icom ID-5100A Full Manual

4
SCAN OPERATION
4-4
Scan (Continued)
D Whenasignalisreceived
When a signal is received, the scan pauses for approxi-
mately 10 seconds (default), then resumes.
The scan resumes approximately 2 seconds (default)
after the signal disappears.
To manually resume the scan, rotate [DIAL].
• These settings can be changed in the Menu screen.
(p. 12-14)
(Scan > PauseTimer)
(Scan > ResumeTimer)
The S-meter shows the
received signal strength.
Blinks
Blinks
D Scanname
A desired name can be assigned to each Program scan
edge or Program scan link channel. (p. 4-12)
By selecting the scan name, the scanning frequency
range will be set.
Scan name
The scan type setting window
D ScanStopBeepfunction
The Scan Stop Beep function sounds a beep when a
signal is received.
The function can be turned ON or OFF in the Menu
screen. (p. 12-61)
(Sounds > ScanStopBeep)
When receiving a signal
The S-meter shows the
received signal strength.
Blinks
Blinks
Beep
D ScanfunctionduringDualwatchmode
When the DV signal is simultaneously received on both
MAIN and SUB bands, the SUB band audio signal is
muted.
Example: While receiving a DV signal on the MAIN
band, the transceiver receives other DV sig-
nal on the SUB band.
You can hear only the MAIN band audio.
The SUB band audio signal is muted.
MAIN band SUB band
Example: While waiting for a DV signal on the MAIN
band, the transceiver receives another signal
from a DV repeater on the SUB band.
You can hear the SUB band audio.
Signal is not received.
MAIN band SUB band
Previous view

Icom ID-5100A Specifications

General

Brand	Icom
Model	ID-5100A
Category	Transceiver
Language	English