6
D-STAR OPERATION <BASIC>
6-4
With the DR function, the transceiver has three com-
munication forms, as shown below.
• Local area call: To call through your local area (ac-
cess) repeater.
• Gateway call: To call through your local area (ac-
cess) repeater, repeater gateway and
the internet to your destination re-
peater or individual station’s last used
repeater, using call sign routing.
• Simplex call: To call another station not using a re-
peater.
NOTE:
• Using the repeater list is required to use the DR function. (pp. 7-22 to 7-24)
• Before operating in the duplex mode, be sure to check whether the repeater is busy, or not. If the repeater is busy,
wait until it is clear, or ask for a “break” using a method acceptable to your local procedures.
• The transceiver has a Time-Out Timer function for DV operation. The timer limits a continuous transmission. Warn-
ing beeps will sound approximately 30 seconds before time-out and then again immediately before time-out.
CommunicationFormwiththeDRfunction
Local area call
Gatewaycall
Simplexcall
Access repeater
Hamacho
repeater
Hamacho area
Hirano
repeater
Sapporo
repeater
Hirano area Sapporo area
To Next Page
Loading...
Need help?
General
