6
D-STAR OPERATION <BASIC>
6-31
Reflector operation (Continued)
D Linkingtoareector
If your repeater is not currently linked to a reflector, or
you want to change to another reflector, you can do so
following the steps below. Before linking to another re-
flector, be sure to unlink the current reflector.
Directinputting
Example: Directly enter “REF010BL.”
Touch [DR]. q
Check whether or not “TO” is selected. w
• If “TO” is not selected, touch the “TO” eld.
Touch the “TO” field. e
• Opens the “TO SELECT” screen.
Touch “Reflector.” r
• Opens the “REFLECTOR” screen.
Touch “Link to Reflector.” t
Touch “Direct Input.” y
Touch [+] or [–] one or more times to select the re- u
flector number. (Example: 010)
• Touch [] to cancel, and then return to the previous
screen.
Touch [+] or [–] one or more times on the right-end i
box to select the module letter. (Example: B)
Touch [SET]. o
• The transceiver returns to the DR screen.
• “Link to Reector” and “REF010BL” are displayed in
“TO.”
!0 Hold down [PTT] to link to the reflector.
• The LED1 on the microphone lights red.
To Next Page
Loading...
Need help?
General
