Icom ID-5100A Full Manual

8
GPS OPERATION
8-36
D SettingtheGPSalarm
A GPS alarm can sound when a target position comes
into the alarm area.
This function can be set to the caller station, all GPS
Memory channels, a specified Memory group or a
specified Memory channel.
Adding or editing GPS memory (Continued)
0.25’ 0.25’
0.25’0.25’
N
Your
position
Your
position
Extended range
(approx. 1 km; 1094 Y)
Limited range
(approx. 500 m; 547 Y)
Beeps one times
Beeps three times
Beeps three times
When all channels or group is selected:
Alarmarea1(Settingpluralstations)
When a specified memory is selected:
Alarmarea2(Settingspecicstation)
Point A
Point B
Point C
Example: Set the alarm setting to all GPS memory (All
Memories).
Touch [MENU]. q
Touch “GPS Alarm.” w
(GPS > GPSAlarm)
• If the item is not displayed, touch [∫] or [√] one or more
times to select another page.
Touch “Alarm Select.” e
Touch “Group.” r
Touch “All Memories.” t
• If you want to set the alarm to a GPS memory group,
touch “(No Group)” or “A” to “Z.”
“All Memories” is
displayed
Touch [MENU]. y
• Closes the Menu screen, and “ì” appears on the
screen.
• When either one of the stations in a specied group en-
ters the set range, the beep sounds three times.
• To cancel the GPS alarm, select “OFF” in the step r.
• When the GPS alarm sounds, “GPS ALARM” pops up on
the screen and then “ì” blinks.
GPS alarm sounds, and
“GPS ALARM” pops up.
Blinks
Foryourreference:
When “All Memories”, “A” to “Z” or “(No Group)” is se-
lected, the alarm sounds depend on the “Alarm Area
(Group)” setting in the Set mode.
(GPS > GPS Alarm > AlarmArea(Group))
Previous view

Icom ID-5100A Specifications

General

Brand	Icom
Model	ID-5100A
Category	Transceiver
Language	English