6
D-STAR OPERATION <BASIC>
6-16
Troubleshooting
PROBLEM POSSIBLECAUSE SOLUTION REF.
After you transmit, no signal
is returned from the repeat-
er. (No S-meter indication)
• The repeater setting is wrong.
• Your transmission did not reach the re-
peater.
• Select the correct repeater.
• Correct the repeater frequency, fre-
quency offset, or duplex setting.
• Wait until you are closer to the repeater
and try it again.
• Try to access another repeater.
p. 6-18
—
—
—
After you transmit, the re-
peater replies ‘UR?’ and its
call sign.
• The call was successfully sent, but no
station immediately replied.
• Wait for a while, and try it again. —
After you transmit
, the re-
peater replies ‘RX’ or ‘RPT?’
and the access repeater’s
call sign.
• Your call sign has not been correctly
set into your transceiver.
• Your call sign has not been registered
on a trust sever.
• Your call sign is not recognized at the
repeater.
• Make sure that your call sign is correctly
set into your transceiver.
• Register your call sign on a trust sever
through a D-STAR repeater, or confirm
the registration of the call sign.
p. 6-5
p. 6-7
After you transmit, the ac-
cess repeater replies ‘RPT?’
and its call sign.
• The call sign of the destination repeat-
er is wrong.
• Correctly set the destination repeater
call sign.
—
After you transmit, the re-
peater replies ‘RPT?’ and
call sign of the destination
repeater.
• The repeater cannot connect to the
destination repeater.
• The repeater is busy.
• Check the repeater setting.
• Wait for a while, and try it again.
—
—
Even holding down [DR], the
DR screen does not appear.
• There is no repeater list in your trans-
ceiver.
• Reload the repeater list using the SD
card.
• Enter the Repeater list data directly into
the transceiver.
p. 6-35
p. 7-22 to p.
7-24
Even holding down [RX>CS],
the received call sign does
not set to the destination call
sign to make a call back.
• The transceiver did not correctly re-
ceive the call sign data.
• When a received signal is weak, or a
signal is received during scanning, the
call sign may not be received correctly.
In that case, “--------” appears and error
beeps sound, and a reply call cannot
be made.
• Try it again, after the transceiver has
correctly received the call sign.
—
A Local area call can be
made, but the Gateway call
or destination station call
cannot be made.
• Your call sign (MY) has not been regis-
tered on a D-STAR repeater.
• Register your call sign (MY) on a D-
STAR repeater, or confirm the registra-
tion of the call sign.
p. 6-7
“L” appears on the LCD.
• While receiving data through the Inter-
net, some packets may be lost due to a
network error.
• Wait a while, and try it again.
When the transceiver receives cor-
rupted data, and misidentifies it is as
packet loss, “L” appears, even if it is a
Local area call.
—
“DV” and “FM” icons alter-
nately blink.
• While in the DV mode, an FM signal is
received.
• Wait a while, and try it again.
p. 7-11
To communicate through the repeater, your signal must access to the repeater. When your signal accesses your local
repeater, but it is not sent to the destination repeater, the repeater replies with an status message.
To Next Page
Loading...
Need help?
General
