4
SCAN OPERATION
4-8
Repeatedly scans all programmed Memory channels.
There two types of scans in the memory mode; Memo-
ry scan and memory bank scan.
• Channels set as “PSKIP” or “SKIP” are skipped during
a scan.
• Two or more memory channels, which are not set
as skip channels, must be programmed into start a
memory scan.
D Memory(skip)scan
The memory channels set as “PSKIP” or “SKIP” skip
channels are not scanned.
Touch the Memory channel number. q
• Opens the Mode setting window.
Touch [MR]. w
• Selects the Memory mode.
Touch the Function group icon one or more times. e
• Selects the F-1 menu.
Touch [SCAN]. r
• Opens the scan type setting window.
Touch the desired scan type. t
• ALL: Full scan
• BAND: Band memory scan
• MODE: Mode memory scan
• DUP: Duplex scan (p. 4-2)
( Appears only when duplex is set.)
• TONE: Tone scan
(For tone squelch scanning)
Memoryscan
The scan starts. y
• If desired, rotate [DIAL] during a scan to switch the scan-
ning direction.
• The scan runs even while the Menu or Quick Menu screen
is displayed.
The S-meter shows the
received signal strength.
Whenreceivingasignal
Blinks
Blinks
DuringaMemoryscan
Blinks
Blinks
To cancel the scan, touch [SCAN]. u
• Touching the frequency readout also cancels the scan.
To Next Page
Loading...
Need help?
General
