7½ Digit Graphical Sampling Multimeter Reference Manual Section 3:
DMM7510-901-01 Rev. B / May 2015 3-39
Creating, storing, and performing operations on configuration lists
and indexes
To create a configuration index, you need to:
• Create a new configuration list and give it a name or use a specific configuration list that already
exists on the instrument
• Configure the instrument with the settings that you want to store in a configuration index
• Store the active settings into a configuration index on the specified configuration list
After you store configuration indexes to a configuration list, you can do the following operations on a
specific configuration index:
• Recall a configuration index and restore the stored settings to the active state
• View the contents of a configuration index
• Delete a configuration index or delete the entire configuration list
You can work with configuration lists from the front panel (see
Using the front panel for configuration
list operations (on page 3-39)) or by using remote commands (see Using remote commands for
configuration list operations (on page 3-43)).
Using the front panel for configuration list operations
This section describes how to store the active settings to a specific index on a configuration list.
See What is a configuration index? (on page 3-38
) for information about how the instrument adds
configuration indexes to configuration lists before reading this section.
The following topics provide information to:
• Create an example measure configuration list named MyMeasList.
• Store two example configuration indexes on MyMeasList. The following table provides
information about specific settings for each configuration index.
• View the contents of a specific configuration index.
• Recall a configuration index from MyMeasList.
Front-panel configuration list menu overview
To display the configuration list menus from the main menu:
1. Press the MENU key.
2. Under Measure, select Config Lists. The MEASURE CONFIGURATION LISTS screen is
displayed. Use this menu for operations on measure configuration lists.
To Next Page
Loading...
Need help?
General
