8: TSP command reference Model DMM7510 7½ Digit Graphical Sampling Multimeter
8-242 DMM7510-901-01 Rev. B / May 2015
status.operation.enable
This attribute sets or reads the contents of the Operation Event Enable Register of the status model.
Type TSP-Link accessible Affected by Where saved Default value
Usage
operationRegister = status.operation.enable
status.operation.enable = operationRegister
The status of the operation status register
Details
This command sets or reads the contents of the Enable register of the Operation Event Register.
When one of these bits is set, when the corresponding bit in the Operation Event Register or
Operation Condition Register is set, the OSB bit in the Status Byte Register is set.
Example
-- decimal 20480 = binary 0101 0000 0000 0000
status.operation.enable = operationRegister
Sets the 12 and 14 bits of the operation
status enable register using a decimal
value.
Also see
Operation Event Register (on page 7)
Understanding bit settings (on page 14)
To Next Page
Loading...
Need help?
General
