8: TSP command reference Model DMM7510 7½ Digit Graphical Sampling Multimeter
8-258 DMM7510-901-01 Rev. B / May 2015
trigger.blender[N].wait()
This function waits for a blender trigger event to occur.
Type TSP-Link accessible
Affected by Where saved Default value
Usage
triggered = trigger.blender[N].wait(timeout)
Trigger detection indication for blender
The trigger blender (1 or 2) on which to wait
Maximum amount of time in seconds to wait for the trigger blender event
Details
This function waits for an event blender trigger event. If one or more trigger events were detected
since the last time trigger.blender[N].wait() or trigger.blender[N].clear() was
called, this function returns immediately.
After detecting a trigger with this function, the event detector automatically resets and rearms. This is
true regardless of the number of events detected.
Example
digio.line[3].mode = digio.MODE_TRIGGER_IN
digio.line[5].mode = digio.MODE_TRIGGER_IN
trigger.digin[3].edge = trigger.EDGE_FALLING
trigger.digin[5].edge = trigger.EDGE_FALLING
trigger.blender[1].orenable = true
trigger.blender[1].stimulus[1] = trigger.EVENT_DIGIO3
trigger.blender[1].stimulus[2] = trigger.EVENT_DIGIO5
print(trigger.blender[1].wait(3))
Generate a trigger blender 1
event when a digital I/O
trigger happens on line 3 or
5.
Wait 3 s while checking if
trigger blender 1 event has
occurred.
Also see
trigger.blender[N].clear() (on page 8-254)
To Next Page
Loading...
Need help?
General
