To Next Page

To Previous Page

Model DMM7510

7½ Digit Graphical Sampling Multimeter Reference Manual Section 6:

SCPI command reference

DMM7510-901-01 Rev. B / May 2015 6-159

:TRACe:LOG:STATe

This command indicates if information events are logged when the specified reading buffer is at 0 % or 100 %

filled.

Type Affected by Where saved Default value

Command and query

Recall settings

Instrument reset

Power cycle

Save settings

defbuffer1: 1 (ON)

defbuffer2: 1 (ON)

User-created buffer: 0 (OFF)

Usage

:TRACe:LOG:STATe <logState>

:TRACe:LOG:STATe <logState>, "<bufferName>"

:TRACe:LOG:STATe?

:TRACe:LOG:STATe? "<bufferName>"

Do not log information events:

OFF

Log information events: ON or 1

A string that indicates the reading buffer; the default buffers (defbuffer1 or

defbuffer2) or the name of a user-defined buffer; if no buffer is specified,

defbuffer1 is used

Details

If this is set to on, when the reading buffer is cleared (0 % filled) or full (100 % filled), an event is

logged in the event log. If this is set to off, reading buffer status is not reported in the event log.

Example

TRACe:LOG:STATe?

Query the log state of defbuffer1.

Output:

Indicates that the log state is on.

Also see

Reading buffers (on page 3-13)

Remote buffer operation (on page 3-30)

:TRACe:MAKE (on page 6-160)

Using the event log (on page 2-154)

Keithley DMM7510 Reference Manual

Other manuals for Keithley DMM7510