Keithley DMM7510 Reference Manual

Section
8: TSP command reference Model DMM7510 7½ Digit Graphical Sampling Multimeter
Reference Manual
8-260 DMM7510-901-01 Rev. B / May 2015
trigger.digin[N].clear()
This function clears the trigger event on a digital input line.
Type TSP-Link accessible
Affected by Where saved Default value
Function
Yes
Usage
trigger.digin[N].clear()
N
Digital I/O trigger line (1 to 6)
Details
The event detector of a trigger enters the detected state when an event is detected. For the specified
trigger line, this command clears the event detector, discards the history, and clears the overrun
status(sets the overrun status to false).
Example
trigger.digin[2].clear()
Clears the trigger event detector on I/O line 2.
Also see
digio.line[N].mode (on page 8-52)
Digital I/O port configuration (on page 3-49)
trigger.digin[N].overrun (on page 8-261)
trigger.digin[N].wait() (on page 8-262)
trigger.digin[N].edge
This attribute sets the edge used by the trigger event detector on the given trigger line.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (RW) Yes
Restore configuration
Instrument reset
Power cycle
Configuration script trigger.EDGE_FALLING
Usage
detectedEdge = trigger.digin[N].edge
trigger.digin[N].edge = detectedEdge
detectedEdge
The trigger logic value:
• Detect falling-edge triggers as inputs: trigger.EDGE_FALLING
• Detect rising-edge triggers as inputs: trigger.EDGE_RISING
• Detect either falling or rising-edge triggers as inputs:
trigger.EDGE_EITHER
•
See Details for descriptions of values
N
Digital I/O trigger line (1 to 6)

Keithley DMM7510 Specifications

General

Brand	Keithley
Model	DMM7510
Category	Multimeter
Language	English