7: Introduction to TSP commands Model DMM7510 7½ Digit Graphical Sampling Multimeter
7-36 DMM7510-901-01 Rev. B / May 2015
Adding a new TSP file to a project
To add a new TSP file to a project:
1. Select the File menu and select New > TSP File. The New TSP File dialog box opens.
2. Select the project folder where you want to save the file.
3. Enter a name in the File name box.
4. Click Finish.
Running a script
You can run a script in the Test Script Builder (TSB) software using any of the following methods:
• Run a script that is open in the script editor area
• Run scripts that are listed in the Navigator area that are not currently open in the script editor
window
• Run a collection of scripts by creating a run configuration (see Creating a run configuration (on
page 7-37))
When you use any of the run controls to run a script, the area that has focus in the workspace is
important. For example, if the Navigator area is active (the tab is shaded) when you click the Run
icon, the script file that is highlighted in the Navigator area is run instead of the active script in the
script editor area.
The following list describes the most commonly used controls to run scripts in TSB:
• Right-click in the script editor area and select Run Editor Contents to run the active script as it
currently appears in the script editor
• Right-click in the script editor area and select Run As > 1 TSP File to run the last saved version
of the active script in the script editor as a .tsp file
• Select an action from the Run menu at the top of the TSB software interface
To Next Page
Loading...
Need help?
General
