7½ Digit Graphical Sampling Multimeter Reference Manual Section 6:
DMM7510-901-01 Rev. B / May 2015 6-193
Example
TRIG:BLOC:CONF:PREV 14, "SETTINGS_LIST"
Set trigger block 14 to restore the settings
from the previous index that is stored in the
configuration list SETTINGS_LIST.
Also see
Configuration lists (on page 3-37)
:TRIGger:BLOCk:CONFig:RECall
This command recalls the system settings that are stored in a configuration list.
Type Affected by Where saved Default value
Command only
Recall settings
Instrument reset
Save settings Not applicable
Usage
:TRIGger:BLOCk:CONFig:RECall <blockNumber>, "<configurationList>"
:TRIGger:BLOCk:CONFig:RECall <blockNumber>, "<configurationList>", <index>
The sequence of the block in the trigger model
A string that defines the configuration list to recall
The index in the configuration list to recall; defaults to 1 if not selected
Details
When the trigger model reaches a configuration recall building block, the settings in the specified
configuration list are recalled.
You can restore a specific set of configuration settings in the configuration list by defining the index.
Example
TRIG:BLOCK:CONF:RECALL 1, "SETTINGS_LIST", 1
Recall the settings in index 1 of the
SETTINGS_LIST configuration list as block
Also see
Configuration lists (on page 3-37)
To Next Page
Loading...
Need help?
General
