To Next Page

To Previous Page

Model DMM7510

7½ Digit Graphical Sampling Multimeter Reference Manual Section 6:

SCPI command reference

DMM7510-901-01 Rev. B / May 2015 6-165

:TRACe:SAVE:APPend

This command appends data from the reading buffer to a file on the USB flash drive.

Type Affected by Where saved Default value

Command only

Not applicable

Usage

:TRACe:SAVE:APPend "<fileName>"

:TRACe:SAVE:APPend "<fileName>", "<bufferName>"

:TRACe:SAVE:APPend "<fileName>", "<bufferName>", <timeFormat>

:TRACe:SAVE:APPend "<fileName>", "<bufferName>", <timeFormat>, <start>, <end>

A string that indicates the name of the file on the USB flash drive in which to save

the reading buffer

A string that indicates the reading buffer; the default buffers (defbuffer1 or

defbuffer2) or the name of a user-defined buffer; if no buffer is specified,

defbuffer1 is used

Indicates how date and time information from the buffer is saved in the file on the

USB flash drive; the values are:

• Dates, times, and fractional seconds are saved; the default value: FORMat

• Relative timestamps are saved: RELative

• Seconds and fractional seconds are saved: RAW

• Timestamps are saved: STAMp

<start>

Defines the starting point in the buffer to start saving data

<end>

Defines the ending point in the buffer to stop saving data

Details

If the file you specify does not exist on the USB flash drive, this command creates the file.

For options that save more than one item of time information, each item is comma-delimited. For

example, the default format is date, time, and fractional seconds for each reading.

The file extension .csv is appended to the filename if necessary. Any file extension other than .csv

generates an error.

The index column entry in the .csv file starts at 1 for each append operation.

Keithley DMM7510 Reference Manual

Other manuals for Keithley DMM7510