To Next Page

To Previous Page

Model DMM7510

7½ Digit Graphical Sampling Multimeter Reference Manual Section 6:

SCPI command reference

DMM7510-901-01 Rev. B / May 2015 6-139

:SYSTem:ERRor[:NEXT]?

This command returns the oldest unread error message from the event log and removes it from the log.

Type Affected by Where saved Default value

Query only Not applicable Not applicable Not applicable

Usage

:SYSTem:ERRor[:NEXT]?

Details

As error and status messages occur, they are placed in the event log. The event log is a first-in, first-

out (FIFO) register that can hold up to 1000 messages.

This command returns the next entry from the event log.

This command does not affect the event log that is displayed on the front panel.

If there are no entries in the event log, the following message is returned:

0,"No error;0,0,0"

This command returns only error messages from the event log. To return information and warning

messages, see :SYSTem:EVENtlog:NEXT?.

Note that if you have used :SYSTem:ERRor[:NEXT]? to check events,

:SYSTem:EVENtlog:NEXT? shows the next event item after the last error that was returned by

:SYSTem:ERRor[:NEXT]? You will not see warnings or information event log items that occurred

before you used :SYSTem:ERRor[:NEXT]?

Example

SYST:ERR:NEXT?

Returns information on the next error in the event log. For example, if you

sent a command without a parameter, the return is:

-109,"Missing parameter;1;2015/05/06 12:57:04.484"

Also see

:SYSTem:EVENtlog:NEXT? (on page 6-142)

Keithley DMM7510 Reference Manual

Other manuals for Keithley DMM7510