7½ Digit Graphical Sampling Multimeter Reference Manual Section 6:
DMM7510-901-01 Rev. B / May 2015 6-129
STATus subsystem
The STATus subsystem controls the status registers of the instrument. For additional information on
the status model, see Status model (on page 1
).
:STATus:CLEar
This function clears event registers and the event log.
Type Affected by Where saved Default value
Usage
:STATus:CLEar
Details
This command clears the event registers of the Questionable Event and Operation Event Register
set. It does not affect the Questionable Event Enable or Operation Event Enable registers.
Example
Clear the bits in the registers
Also see
*CLS (on page 2)
:STATus:OPERation:CONDition?
This command reads the Operation Event Register of the status model.
Type Affected by Where saved Default value
Usage
:STATus:OPERation:CONDition?
Details
This command reads the contents of the Operation Condition Register, which is one of the Operation
Event Registers.
For detail on interpreting the value of a register, see Understanding bit settings (on page 14
).
Example
Returns the contents of the Operation
Also see
Operation Event Register (on page 7)
To Next Page
Loading...
Need help?
General
