To Next Page

To Previous Page

Model DMM7510

7½ Digit Graphical Sampling Multimeter Reference Manual Section 6:

SCPI command reference

DMM7510-901-01 Rev. B / May 2015 6-235

Details

This command sets the timer event detector to the undetected state and resets the overrun indicator.

Example

:TRIG:TIM1:CLEar

Clears trigger timer 1.

Also see

:TRIGger:TIMer<n>:COUNt (on page 6-235)

:TRIGger:TIMer<n>:STARt:OVERrun? (on page 6-239)

:TRIGger:TIMer<n>:COUNt

This command sets the number of events to generate each time the timer generates a trigger event or is enabled

as a timer or alarm.

Type Affected by Where saved Default value

Command and query

Recall settings

Instrument reset

Power cycle

Save settings 1

Usage

:TRIGger:TIMer<n>:COUNt <count>

:TRIGger:TIMer<n>:COUNt?

<n>

Trigger timer number (1 to 4)

<count>

The number of times to repeat the trigger (0 to 1,048,575)

Details

If count is set to a number greater than 1, the timer automatically starts the next trigger timer delay

at the expiration of the previous delay.

Set count to zero (0) to cause the timer to generate trigger events indefinitely.

If you use the trigger timer with a trigger model, make sure the count value is the same or more than

any count values expected in the trigger model.

Example 1

TRIG:TIM2:COUN 4

Set the number of events to generate for trigger

timer 2 to four.

Keithley DMM7510 Reference Manual

Other manuals for Keithley DMM7510