To Next Page

To Previous Page

Model DMM751

0 7½ Digit Graphical Sampling Multimeter Reference Manual Section 6:

SCPI command reference

DMM7510-901-01 Rev. B / May 2015 6-233

x is limit 1, 2, 3, or 4; the upper limit that the measurement is compared

against

x is 1, 2, 3, or 4; the lower limit that the measurement is compared against

The bit pattern that is sent when the measurement passes limit 1; range 1

to 15; default is 1

The bit pattern that is sent when the measurement passes limit 2; range 1

to 15; default is 2

The bit pattern that is sent when the measurement passes limit 3; range 1

to 15; default is 4

The bit pattern that is sent when the measurement passes limit 4; range 1

to 15; default is 8

The bit pattern that is sent when all limits have failed; 1 to 15; default is 15

A string that indicates the reading buffer; the default buffers (defbuffer1

or defbuffer2) or the name of a user-defined buffer; if no buffer is

specified, defbuffer1 is used

Details

This trigger model template allows you to sort components and place them into up to four bins, based

on the comparison to limits.

To set a limit as unused, set the high value for the limit to be less than the low limit.

All limit patterns and the all fail pattern are sent on digital I/O lines 1 to 4, where 1 is the least

significant bit.

The out line of the EXT TRIG IN/OUT rear-panel terminal is asserted at the end of each

measurement.

After selecting a trigger model template, you can view the trigger model blocks in a graphical format

by pressing the front-panel MENU key and under Trigger, selecting Configure. You can also add or

delete blocks and change trigger model settings from this screen. You can use the

TRIGger:BLOCk:LIST? command to view the trigger model blocks in a list format.

Example

For a detailed example, see the section in the Model DMM7510 User's Manual named "Grading and

binning resistors."

Also see

None

Keithley DMM7510 Reference Manual

Other manuals for Keithley DMM7510