To Next Page

To Previous Page

Section

8: TSP command reference Model DMM7510 7½ Digit Graphical Sampling Multimeter

Reference Manual

8-298 DMM7510-901-01 Rev. B / May 2015

Trigger events

Event description Event constant

Trigger event blender N (1 to 2), which combines trigger

events

trigger.EVENT_BLENDERN

Trigger timer N (1 to 4) expired

trigger.EVENT_TIMERN

Analog trigger

trigger.EVENT_ANALOGTRIGGER

External in trigger

trigger.EVENT_EXTERNAL

After selecting a trigger model template, you can view the trigger model blocks in a graphical format

by pressing the front-panel MENU key and under Trigger, selecting Configure. You can also add or

delete blocks and change trigger model settings from this screen. You can use the

trigger.model.getblocklist() command to view the trigger model blocks in a list format.

The following usage has been deprecated; replace it with the usage above that includes the clear

parameter.

trigger.model.load("LoopUntilEvent", triggerEvent, position)

trigger.model.load("LoopUntilEvent", triggerEvent, position, delay)

trigger.model.load("LoopUntilEvent", triggerEvent, position, delay, bufferName)

trigger.model.load("LoopUntilEvent", triggerEvent, position, delay, bufferName,

readingBlock)

Example

reset()

-- Set up measure function

dmm.measure.func = dmm.FUNC_DC_CURRENT

-- Initiate readings

trigger.model.load("LoopUntilEvent", trigger.EVENT_DISPLAY, 50)

trigger.model.initiate()

Reset the instrument.

Set the instrument to measure current.

Load the LoopUntilEvent trigger model to make measurements until the front panel trigger key is pressed,

then continue to make measurements equal to 50 % of the reading buffer size.

Start the trigger model.

Also see

None

Keithley DMM7510 Reference Manual

Other manuals for Keithley DMM7510