To Next Page

To Previous Page

8 Start, stop and rotang

direcon commands

8.1 Control selecon

Parameter

Address Name / seng range / [default seng] Info

0x2824 Control selecon

•

Seng can only be changed if the inverter is inhibi-

ed.

Selecon of the type of inverter control.

0 Flexible I/O conguraon This selecon enables a exible assignment of the start, stop, and rotat-

ing direcon commands with digital signal sources.

•

Digital signal sources can be digital inputs, network and keypad.

•

The I/O conguraon is made via the parameters 0x2631:xx (P400.xx).

1 Keypad This selecon enables the motor to be started exclusively via the start

ey of the keypad. Other signal sources for starng the motor are

ignored.

Start motor Stop motor

Not

•

The funcons "Enable inverter" and "Run" must be set to TRUE to

start the motor.

•

If jog operaon is acve, the motor cannot be stopped via the

keypad key.

Start, stop and rotang

direcon commands

Control selecon

129

Lenze I95AE240F User Manual

Other manuals for Lenze I95AE240F