Lenze I95AE240F User Manual

17.2 Reset parameters to default
P
arameter
Address Name / seng range / [default seng] Info
0x2022:001 Device commands: Load default sengs 1 ≡ reset all parameters in the RAM memory of the inverter to the
de
fault seng that is stored in the inverter rmware.
•
All par
ameter changes made by the user are lost during this process!
•
It may take some seconds to execute the task. When the task has
been executed successfully, the value 0 is shown.
•
Loading parameters has a direct eect on the cyclic communicaon:
The data exchange for control is interrupted and a communicaon
error is generated.
0 O / ready Only status feedback
1 On / start Execute device command
2 In progress Only status feedback
3 Acon cancelled
4 No access
5 No access (Inverter disabled)
0x2022:039 Device commands: Load TA default sengs
0 O / ready Only status feedback
1 On / start Execute device command
2 In progress Only status feedback
3 Acon cancelled
4 No access
5 No access (Inverter disabled)
Device
funcons
Reset parameters to default
354

Lenze I95AE240F Specifications

General

Brand	Lenze
Model	I95AE240F
Category	Inverter
Language	English