Lenze I95AE240F User Manual

19.2 Safe Emergency Stop (SSE)
The SSE safety funcon has the highest priority. The SSE safety funcon is primarily triggered
fr
om all states, operang modes or safety funcons. Depending on the parameter seng in
0x28A3:0010x28A3:001, the emergency stop funcon acvates one of the funcons:
4Safe Torque O (STO)
4Sa
fe Stop 1 (SS1)
NOTICE
Emergency stop buons must not be overruled by a special operaon.
Otherwise the
funconal safety of the system cannot be guaranteed anymore.
▶
Please observe the notes in the secon
.
▶
Please observe the notes regarding the special operaon (OMS) in the secon
4
Operaon mode selector (OMS). ^ 410
Precondions
The emergency stop buons are connected to the emergency stop funcon.
Details
The
funcon is acvated by the following:
•
a da
ta telegram with a corresponding content is sent to the inverter via the safety bus.
•
"OFF state" at a safe input which has been assigned to the funcon by parameterisaon.
Via a safe input, if the corresponding parameter is assigned to the safe input.
Acvaon of the
funcon
A data telegram is sent to the inverter via the safety bus. See chapter "Safe network interfa-
ces". ^ 417
Parameter
Address Name / seng range / [default seng] Info
0x28A1 SSE: Source SD-In
•
R
ead only
0 Deacvated
1 SD-In1
2 SD-In2
3 SD-In3
4 SD-In4
0x28A2 SSE: Source S-Bus
•
Read only
0 Deacvated
1 Acvated
0x28A3:001 SSE: SSE: Emergency Stop funcon
•
R
ead only
0 STO
1 SS1
0x28A4 SSE acve: Output
•
R
ead only
0 Deacvated
1 SD-Out1 posive logic
2 SD-Out1 negave logic
Safety
funcons
Safe Emergency Stop (SSE)
376

Lenze I95AE240F Specifications

General

Brand	Lenze
Model	I95AE240F
Category	Inverter
Language	English