pool vrf
To enable distributed address pool service on a vrf and to enter the corresponding configuration submode,
use the pool vrf command in the Global Configuration mode. To disable this feature, use the no form of this
command.
pool vrf {vrf_name| all}{ipv4| pool_name| ipv6| pool_name}
no pool vrf {vrf_name| all}{ipv4| pool_name| ipv6| pool_name}
Syntax Description
Specifies the name of the vrf.
vrf_name
Specifies IPv4 pool name. Each pool must have a
unique name across all VRFs.
ipv4
Specifies IPv6 pool name. Each pool must have a
unique name across all VRFs.
ipv6
Specifies the name of the pool for IPv4 or IPv6.
pool_name
Specifies the global pool.all
Command Default
None
Command Modes
Global Configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Support for IPv6 was added.Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the pool ipv4 command to enter IPv4 pool configuration submode and pool ipv6 command to enter IPv6
pool configuration submode.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
90
Address Pool Service Commands
pool vrf
To Next Page
Loading...
Need help?
General
