IPv4 and IPv6 Commands
This module describes the Cisco IOS XR software commands used to configure the IPv4 and IPv6 commands
for Broadband Network Gateway (BNG) on the Cisco ASR 9000 Series Router. For details regarding the
related configurations, refer to the Cisco ASR 9000 Series Aggregation Services Router Broadband Network
Gateway Configuration Guide.
•
ipv4 mtu (BNG), page 298
•
ipv4 unnumbered (point-to-point -BNG), page 300
•
ipv4 unreachables disable (BNG), page 302
•
ipv4 verify unicast source reachable-via (BNG), page 304
•
ipv6 enable (BNG), page 306
•
ipv6 mtu (BNG), page 308
•
ipv6 unreachables disable (BNG), page 310
•
show ipv4 interface (BNG), page 312
•
show ipv4 traffic (BNG), page 315
•
show ipv6 interface (BNG), page 317
•
show ipv6 neighbors (BNG), page 322
•
show ipv6 neighbors summary (BNG), page 328
•
show ipv6 traffic (BNG), page 330
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
297
To Next Page
Loading...
Need help?
General
