show dhcp ipv4 proxy statistics
To display statistics for a specific bridge domain, use the show dhcp ipv4 proxy statistics command in the
EXEC mode.
show dhcp ipv4 proxy statistics location |]
Syntax Description
Specifies the node information for dhcp ipv4 proxy.location
Displays the output modifiers.|
Command Default
Displays a table of DHCP proxy statistics.
Command Modes
EXEC mode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes the proper task
IDs. If you suspect user group assignment is preventing you from using a command, contact your AAA
administrator for assistance.
Task ID
OperationsTask ID
readip-services
Examples
This is the sample output of the show dhcp ipv4 proxy statistics command:
RP/0/RSP0/CPU0:router# show dhcp ipv4 proxy statistics
The show dhcp ipv4 proxy statistics output is as follows:
Wed Jan 23 17:07:12.386 IST
VRF | RX | TX | DR
|
-------------------------------------------------------------------------------------------
default | 0 | 0 | 0 |
**nVSatellite | 0 | 0 | 0 |
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
203
BNG DHCP Commands
show dhcp ipv4 proxy statistics
To Next Page
Loading...
Need help?
General
