Cisco A9K-SIP-700 Command Reference

show qos interface (BNG)
To display QoS information for a specific interface, use the show qos interface command in the EXEC mode.
show qos interface type interface-path-id {input| output} {member type interface-path-id}[host-link
interface-path-id| location node-id]
Syntax Description
Interface type. For more information, use the question
mark (?) online help function.
type
Either a physical interface instance or a virtual
interface instance as follows:
•
Physical interface instance. Naming notation is
rack/slot/module/port and a slash between
values is required as part of the notation.
◦
rack : Chassis number of the rack.
◦
slot : Physical slot number of the modular
services card or line card.
◦
module : Module number. A physical
layer interface module (PLIM) is always
0.
◦
port : Physical port number of the
interface.
In references to a Management
Ethernet interface located on a route
processor card, the physical slot
number is alphanumeric ( RSP0 RP0
or RP1 ) and the module is CPU0.
Example: interface MgmtEth0/ RSP0
RP1 /CPU0/0.
Note
•
Virtual interface instance. Number range varies
depending on interface type.
For more information about the syntax for the router,
use the question mark (?) online help function.
interface-path-id
Attaches the specified policy map to the input
interface.
input
Attaches the specified policy map to the output
interface.
output
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
494
QOS Commands
show qos interface (BNG)

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English