Cisco A9K-SIP-700 Command Reference

Each pool must have a unique name across all VRFs. For example, pool1 can not be created in both vrf1
and vrf2.
Note
Some pools can be associated with all the VRFs and these pools are configured with the all keyword.
Task ID
OperationTask ID
read, writeip-services
Examples
This is an example of configuring the pool vrf command for IPv4 in the Global Configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# pool vrf vrf1 ipv4 pool2
RP/0/RSP0/CPU0:router(config-pool-ipv4)#
This is an example of configuring the pool vrf command for IPv6 in the Global Configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# pool vrf vrf1 ipv6 pool3
RP/0/RSP0/CPU0:router(config-pool-ipv6)#
Related Commands
DescriptionCommand
Enables distributed address pool service on IPv4.pool ipv4, on page 92
Enables distributed address pool service on IPv6.pool ipv6, on page 94
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
91
Address Pool Service Commands
pool vrf

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English