framed-prefix-pool
To specify the default pool name for ipv6 prefixes for assignment only from SLAAC (Stateless Address
Auto-Configuration), use the framed-prefix-pool command in the dynamic template configuration mode.
To remove the framed prefix pool name, use the no form of this command.
framed-prefix-pool pool_name
no framed-prefix-pool pool_name
Syntax Description
Specifies the name of a prefix pool.
pool_name
Command Default
None
Command Modes
Dynamic template configuration
Command History
ModificationRelease
This command was introduced.Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
To enter the dynamic template configuration mode, enter dynamic-template command in the Global
Configuration mode.
The dynamic template configuration is used when Radius does not return pool name or prefix for the SLAAC.
Task ID
OperationsTask ID
read, writeconfig-services
Examples
This is an example of creating a framed prefix pool name using the framed-prefix-pool command:
RP/0/RSP0/CPU0:router(config)# dynamic-template
RP/0/RSP0/CPU0:router(config-dynamic-template)# type ipv6
RP/0/RSP0/CPU0:router(config-dynamic-template-type)# framed-prefix-pool my-slaac-pool
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
158
BNG DHCP Commands
framed-prefix-pool
To Next Page
Loading...
Need help?
General
