Examples
This is an example of configuring the address-range command for IPv4 in the Global Configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# pool vrf vrf1 ipv4 pool2
RP/0/RSP0/CPU0:router(config-pool-ipv4)# address-range 11.11.11.11 14.14.14.14
This is an example of configuring the address-range command for IPv6 in the Global Configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# pool vrf vrf1 ipv6 pool3
RP/0/RSP0/CPU0:router(config-pool-ipv6)# address-range 2001::1 2001::100
Related Commands
DescriptionCommand
Enables distributed address pool service on ipv4.pool ipv4, on page 92
Enables distributed address pool service on vrf.pool vrf, on page 90
Specifies a range of IP addresses that distributed
address pool service should not assign to clients.
exclude, on page 82
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
81
Address Pool Service Commands
address-range
To Next Page
Loading...
Need help?
General
