radius-server throttle
To configure RADIUS throttling options for access and accounting to flow control the number of access and
accounting requests sent to a RADIUS server, use the radius-server throttle command in the Global
Configuration mode. To disable the radius server throttle, use the no form of this command.
radius-server throttle {access value {access-timeout time| accounting value}| accounting acc_value}
no radius-server throttle {access value {access-timeout time| accounting value}| accounting acc_value}
Syntax Description
Controls the number of access requests sent to a radius server.access
Specifies the number of outstanding access requests after which throttling should
be performed. The value ranges from 0 to 65535 and the preferred value 100.
value
Specifies the number of timeouts exceeding which a throttled access request is
dropped.
access-timeout
Specifies the number of timeouts for a transaction. The default value is 3.
time
Controls the number of accounting requests sent to a radius server.accounting
Specifies the number of outstanding accounting transactions after which throttling
should be performed. The value ranges from 0 to 65535 and the preferred value
100.
acc_value
Command Default
None
Command Modes
Global Configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.2.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, writeaaa
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
51
BNG AAA Commands
radius-server throttle
To Next Page
Loading...
Need help?
General
