show pppoe summary
To show the summary information for the PPPoE sessions, use the show pppoe summary command in the
EXEC mode mode.
show pppoe summary {per-access-interface| total}{ location| node}
Syntax Description
Summarizes PPPoE sessions running on each access-interface.per-access-interface
Shows the overall summary information of access-interfaces and sessions.total
Shows PPPoE status for all sessions at a location.location
Specifies the fully qualified location specification.
node
Command Default
None
Command Modes
EXEC mode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes the proper task
IDs. If you suspect user group assignment is preventing you from using a command, contact your AAA
administrator for assistance.
Task ID
OperationTask ID
readppp
Examples
This is the sample output of the show pppoe summary command:
RP/0/RSP0/CPU0:router# show pppoe summary per-access-interfaces location 0/1/cpu0
COMPLETE: Complete PPPoE Sessions
INCOMPLETE: PPPoE sessions being brought up or torn down
Interface BBA-Group READY TOTAL COMPLETE INCOMPLETE
-------------------------------------------------------------------------------
Fa0/1/0/0 blue Y 20 18 2
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
473
PPPoE Commands
show pppoe summary
To Next Page
Loading...
Need help?
General
