router igmp vrf
To configure route-policy to be used to map the bandwidth profile, use the router igmp vrf command in the
Global Configuration mode. To disable this feature, use the no form of this command.
router igmp vrf vrf_name {traffic| profile| profile_name}
no router igmp vrf vrf_name {traffic| profile| profile_name}
Syntax Description
Specifies the VRF name.
vrf_name
Configures IGMP traffic variables.traffic
Configures route-policy to be used to map the
bandwidth profile.
profile
Specifies the profile name.
profile_name
Command Default
None
Command Modes
Global Configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, writemulticast
Examples
This is an example of configuring the router igmp vrf command in the Global Configuration mode:
RP/0/RSP0/CPU0:router # configure
RP/0/RSP0/CPU0:router(config)# router igmp vrf vrf1
RP/0/RSP0/CPU0:router(config)# router igmp vrf vrf1 traffic profile prof-name
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
334
Multicast Commands
router igmp vrf
To Next Page
Loading...
Need help?
General
