pool ipv4
To enable distributed address pool service on IPv4 and to enter the pool IPv4 configuration submode, use the
pool ipv4 command in the Global Configuration mode. To disable this feature, use the no form of this
command.
pool ipv4 pool_name
no pool ipv4 pool_name
Syntax Description
Specifies the name of the IPv4 pool.
pool_name
Command Default
None
Command Modes
Global Configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the pool ipv4 command to enter IPv4 pool configuration submode.
Task ID
OperationTask ID
read, writeip-services
Examples
This is an example of configuring the pool ipv4 command in the Global Configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# pool ipv4 pool1
RP/0/RSP0/CPU0:router(config-pool-ipv4)# address-range 10.10.10.1 10.10.10.254
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
92
Address Pool Service Commands
pool ipv4
To Next Page
Loading...
Need help?
General
