Cisco A9K-SIP-700 Command Reference

lpts punt excessive-flow-trap penalty-timeout
To set the penalty timeout value for a protocol, use the lpts punt excessive-flow-trap penalty-timeout
command in Global Configuration mode. To restore the default penalty timeout value, use the no form of this
command.
lpts punt excessive-flow-trap penalty-timeout{trace| arp| icmp| dhcp| pppoe| ppp| igmp| ip| l2tp| all|
interface| information} timeout
no lpts punt excessive-flow-trap penalty-timeout{trace| arp| icmp| dhcp| pppoe| ppp| igmp| ip| l2tp| all|
interface| information}
Syntax Description
Sets the default penalty timeout for all protocols.default
Sets the penalty timeout for the ARP protocol.arp
Sets the penalty timeout for the ICMP protocol.icmp
Sets the penalty timeout for the DHCP protocol.dhcp
Sets the penalty timeout for the PPPoE protocol.pppoe
Sets the penalty timeout for the PPP protocol.ppp
Sets the penalty timeout for the IGMP protocol.igmp
Sets the penalty timeout for the IPv4 protocol.ip
Sets the penalty timeout for the L2TP protocol.l2tp
Command Default
The default value in minutes is 15.
Command Modes
Global Configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
257
Excessive Punt Flow Trap Commands
lpts punt excessive-flow-trap penalty-timeout

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English