Cisco A9K-SIP-700 Command Reference

timeout idle
To configure an idle timeout period for the IPoE and PPPoE subscriber sessions on BNG, use the timeout
idle command in dynamic template type configuration mode. To disable this feature, use the no form of this
command.
timeout idle seconds [threshold rate] [traffic {both| inbound| outbound}]
no timeout idle seconds [threshold duration] [traffic {both| inbound| outbound}]
Syntax Description
Idle timeout value for the subscriber sessions, in
seconds.
The range is from 60 to 4320000.
seconds
Configures a threshold to track the duration of
session idleness.
threshold
Duration of threshold, in minute(s) per packet.
The range is from 1 to 10000. Default is 0.
This value should be less than the idle
timeout value.
Note
duration
Considers the direction of traffic while deriving
the duration of session idleness.
The default is inbound direction.
traffic
Considers inbound and outbound traffic while
deriving the duration of session idleness.
both
Considers inbound traffic only while deriving the
duration of session idleness.
inbound
Considers outbound traffic only while deriving the
duration of session idleness.
outbound
Command Default
None
Command Modes
Dynamic template type configuration
Command History
ModificationRelease
This command was introduced.Release 4.2.1
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
246
Dynamic Template Commands
timeout idle

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English