source-interface (subscriber redundancy)
To configure the interface whose IP address must be used for peering with other routers in BNG geo redundancy
scenario, use the source-interface command in subscriber redundancy configuration mode. To remove this
configuration, use the no form of this command.
source-interface interface-type interface-name
no source-interface interface-type interface-name
Syntax Description
Type of the source interface.
interface-type
Name of the source interface.
interface-name
Command Default
None
Command Modes
Subscriber redundancy configuration
Command History
ModificationRelease
This command was introduced.Release 5.2.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
It is recommended to use a loopback address that is advertised from the router for peer and the interface must
have IPv4 or IPv6 (or both) global address depending on which one is to be used for peering.
Task ID
OperationTask ID
read, writeconfig-services
Examples
This example shows how to configure source interface in subscriber redundancy sub-mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# subscriber redundancy
RP/0/RSP0/CPU0:router(config-subscr-red)# source-interface loopback0
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
524
Subscriber Commands
source-interface (subscriber redundancy)
To Next Page
Loading...
Need help?
General
