hold-timer (subscriber redundancy)
To configure the duration for which the dynamic switchover is suspended after a role change in BNG geo
redundancy feature scenario, use the hold-timer command in subscriber redundancy configuration mode. To
configure hold timer for a specific subscriber redundancy group (SRG), use this command in subscriber
redundancy group configuration mode. To remove the hold timer configuration, use the no form of this
command.
hold-timer hold-timer
no hold-timer hold-timer
Syntax Description
Hold timer value, in minutes.
The range is from 1 to 65535.
hold-timer
Command Default
By default, the hold-time is zero. That is, back to back switchovers are allowed.
Command Modes
Subscriber redundancy
Subscriber redundancy group
Command History
ModificationRelease
This command was introduced.Release 5.2.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
This is an optional command.
Task ID
OperationTask ID
read, writeconfig-services
Examples
This example shows how to configure hold-timer across all SRGs, in BNG geo redundancy feature scenario:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# subscriber redundancy
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
518
Subscriber Commands
hold-timer (subscriber redundancy)
To Next Page
Loading...
Need help?
General
