Cisco A9K-SIP-700 Command Reference

network (BNG)
To specify a set of addresses or prefixes inside a subnet, use the network command in Pool IPv4 or IPv6
configuration submode. To remove the addresses or prefixes, use the no form of this command.
network {IPv4_subnet/length [default-router default-router-address ]| IPv6_subnet/length}
no network {IPv4_subnet/length [default-router default-router-address ]| IPv6_subnet/length}
Syntax Description
Specifies the decimal representation of the IPv4
subnet mask.
IPv4_subnet
Specifies the hexadecimal value for the IPv6 subnet
mask.
IPv6_subnet
Specifies the length of the prefix.
The prefix length must be a maximum of 16
bit more than the subnet mask.
Note
length
(Optional) Specifies the default-gateway address for
the subnet.
default-router
IPv4 address of the default-gateway.
default-router-address
Command Default
None
Command Modes
Pool IPv4 configuration
Pool IPv6 configuration
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Support for IPv6 was added.Release 4.3.0
Support for IPv4 default-router was added.Release 5.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
84
Address Pool Service Commands
network (BNG)

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English