ppp ipcp
To set Internet Protocol Control Protocol (IPCP) negotiation options, use the ppp ipcp command in the
dynamic template configuration mode. To disable this feature, use the no form of this command.
ppp ipcp [ dns{ primary_ip_address| secondary_ip_address } | mask peer_netmask_address | peer-address{
default| peer_ipaddress| pool| pool_name } | renegotiation ignore | wins |primary_ipaddress
|secondary_ipaddress ]
no ppp ipcp
Syntax Description
Configures the dns options.dns
Specifies the primary DNS IP addresses.
primary_ip_address
Specifies the secondary DNS IP addresses.
secondary_ip_address
Specifies the IPv4 netmask to use for the peer.mask
Specifies the peer netmask address.
peer_netmask_address
Specifies the change in peer-address configuration.peer-address
Specifies the default peer IP address.default
Specifies the peer IP address.
peer_ipaddress
Configures the pool options.pool
Specifies the pool name.
pool_name
Specifies the peer negotiation options.renegotiation
Specifies the WINS options.wins
Command Default
None
Command Modes
Dynamic template configuration
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
383
BNG PPP Commands
ppp ipcp
To Next Page
Loading...
Need help?
General
