Cisco A9K-SIP-700 Command Reference

domain-name (DHCP IPv6 pool-BNG)
To configure a domain name for a Dynamic Host Configuration Protocol (DHCP) for IPv6 client, use the
domain-name command in an appropriate configuration mode. To remove the domain name, use the no form
of this command.
domain-name domain
no domain-name
Syntax Description
Specifies the domain name string to be used by the client.
domain
Command Default
When a DHCP for IPv6 pool is first created, no domain name for clients is configured.
Command Modes
DHCP IPv6 server profile configuration
DHCP IPv6 server profile class configuration
Command History
ModificationRelease
This command was supported in DHCP IPv6 server profile and class
configuration mode in BNG.
Release 4.3.0
Usage Guidelines
Multiple Domain Name System (DNS) domain names can be configured by issuing the domain-name
command multiple times. The new domain name does not overwrite existing domain names.
To enter the DHCP IPv6 server profile configuration, enter profile profile_name server command in the
DHCPv6 configuration mode.
To enter the DHCP IPv6 server profile class configuration, enter class class_name command in the DHCPv6
server profile configuration mode.
The domain name is defined in DHCP IPv6 server profile and DHCP IPv6 server profile class configuration.
If the same parameters are defined in the class scope, then the values defined in the class scope takes precedence.
Task ID
OperationsTask ID
read, writeip-services
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
154
BNG DHCP Commands
domain-name (DHCP IPv6 pool-BNG)

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English