Cisco A9K-SIP-700 Command Reference

show ipsubscriber interface
To display the interface information for the IP subscriber interfaces, use the show ipsubscriber interface
command in the EXEC mode.
show ipsubscriber interface {type interface-path-id| access-interface| address-family| brief| dynamic-routes
[location node-id]| location node-id| outer-vlan-id id [inner-vlan-id id]| subscriber-ip| subscriber-label |
subscriber-mac| vrf}
Syntax Description
Interface type. For more information on interface types
available for this command, use the question mark (?)
online help function.
type
Physical interface or virtual interface.
Use the show interfaces command to see
a list of all interfaces currently configured on
the router.
Note
For more information about the syntax for the router,
use the question mark ( ? ) online help function.
interface-path-id
Specifies the access or parent interface.access-interface
Specifies the address-family in which the IP subscriber
interface operates.
address-family
Displays the brief summary of IP Subscriber access
interface status and configuration.
brief
Specifies the dynamic routes.dynamic-routes
Specifies the IP subscriber location.location
Specifies the fully qualified location specification.
node-id
Specifies the subscriber outer VLAN ID.outer-vlan-id
Outer VLAN ID. The range is from 1 to 4094.
id
Specifies the subscriber inner VLAN ID.inner-vlan-id
Inner VLAN ID. The range is from 1 to 4094.
id
Specifies the subscriber IPv4 address.subscriber-ip
Specifies the subscriber label.subscriber-label
Specifies the subscriber MAC address.subscriber-mac
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
289
IPoE Commands
show ipsubscriber interface

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English