show pool ipv4 name
To display the status of an IPv4 pool, use the show pool ipv4 name command in the EXEC mode.
show pool ipv4 name pool_name{location| verbose| }
Syntax Description
Specifies the name of the IPv4 pool.
pool_name
Specifies the location of the IPv4 pool.location
Displays all allocations for the pools.verbose
Specifies the output modifiers.|
Command Default
None
Command Modes
EXEC mode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Support for IPv6 was added.Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes the proper task
IDs. If you suspect user group assignment is preventing you from using a command, contact your AAA
administrator for assistance.
Use thepool ipv4 command to enter Pool IPv4 configuration submode.
Task ID
OperationTask ID
readip-services
Examples
This is the sample output of the show pool ipv4 name command:
RP/0/RSP0/CPU0:router# show pool ipv4 name POOL1
Pool POOL1 Allocations
---------------------------------------------------
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
98
Address Pool Service Commands
show pool ipv4 name
To Next Page
Loading...
Need help?
General
